Motor cu reductor 34:1 (20D x 42L mm)Cod DMC3125/34
Pret: 65.00 Lei
Motor cu reductor 34:1 (20D x 42L mm)
This gearmotor is a brushed DC motor with 34:1 metal gearbox that has the power to deliver both speed and torque. These units have a 4 mm-diameter D-shaped output shaft.
Key specs at 6 V: 180 RPM and 250 mA free-run, 4.3 kg-cm and 3.3 A stall.
The gearmotor face plate has two mounting holes threaded for M2.5 screws, and you can use our custom-designed 20D mm metal gearmotor bracket (shown in the left picture below) to mount the gearmotor to your project via these mounting holes and the screws that come with the bracket.
20D mm gearmotor with bracket and hub.
White 60×8mm wheel on a 20D mm metal gearmotor.
20D mm metal gearmotor dimensions (units in mm, L=18.5mm).
Note: These motors are intended for use at 6 V. In general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range. Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor.
Size: 20D x 44L mm
Weight: 43 g
Shaft diameter: 4 mm
Gear ratio: 34:1
Free-run speed @ 6V: 180 rpm
Free-run current @ 6V: 250 mA
Stall current @ 6V: 3300 mA
Stall torque @ 6V: 60 oz·in